Description

The Dogtra collar strap 3/4 x 32 is the longer version of Dogtra’s 3/4 inch strap, giving extra length for bigger necks on systems that use a 3/4 inch strap. It comes in black, green, yellow, orange and blue.

Will the Dogtra Collar Strap 3/4 x 32 fit?

It fits systems that use a 3/4 inch strap. If your current strap is 3/4 inch wide but too short, this is the one.

Getting the fit right

Fit the receiver on the side of the neck high up, then tighten until you can slide one finger under the strap. Trim any long tail so it doesn’t flap, and seal the cut end with a lighter if it’s nylon.

Swapping the strap

It’s a two-minute job. Undo the strap from the receiver, feed the new one through, and check the buckle holds. Give it a firm pull before your dog wears it.

Caring for collar straps

Straps take a beating from water, sun and teeth. Wash them now and then, dry them flat and keep an eye on the buckle. They’re cheap to replace, and a snapped strap usually means a lost receiver.

Which strap fits my collar?

Quick guide. The 3/4 x 28 inch strap fits smaller receivers like the 280X, iQ, 200C and 280C. The 3/4 x 32 inch is the same width with extra length for bigger necks. The 1 x 30 inch fits larger receivers like the 1900X, ARC, 1900S, 2300NCP and Edge. T&B collars use the 1 x 24 inch T&B strap, and the YS300 has its own 3/4 x 24 inch strap. Dogtra’s manuals are on Dogtra’s website.

Pairs well with

If you’re changing straps on an older receiver, it’s a good time to check the charging cap and contact points too.

Ordering tips

Ordering for more than one dog or system? Put it all in one order and it arrives in one box. If you’re not completely sure which part matches which unit, list your models in the order notes or message us first and we’ll check every part against your list before anything ships. Easy.

Why genuine

No copies here. Everything is original Dogtra. That matters with small parts too, because a part that’s slightly the wrong size can affect fit, waterproofing or contact.